The 1961–1964 Ford Truck Dual-Flex Drop Front Leaf Springs (Pair) by Posies (Part #D164F) is a performance front suspension lowering kit engineered specifically for fourth-generation Ford F-100 pickups (1961, 1962, 1963, and 1964 2WD).
Designed to lower the front ride height by 2-1/2" to 3", these springs combine modern full-taper leaf technology with a dual-leaf configuration to provide a sleek, dropped stance, superior ride comfort, and a 100% increase in safety compared to traditional single mono-leaf springs.
Product Overview & Performance
Factory multi-leaf front springs on early 1960s F-100 trucks are notoriously stiff, resulting in a harsh, bouncy ride over road imperfections. While mono-leaf springs are often used to drop front ends, they lack redundancy and risk catastrophic failure if the single leaf breaks.
Posies solves this with their Dual-Flex full-taper leaf technology. The two-leaf tapered design provides the clean, minimal aesthetic of a mono-leaf with a secondary full-length leaf for fail-safe structural redundancy. Combined with Posies' signature moly-nylon SuperSlide buttons, inter-leaf friction and binding are eliminated, allowing the front beam axle to react smoothly to bumps while maintaining tight, predictable handling.
Key Features & Design Highlights
-
2-1/2" to 3" Lowered Front Stance: Drops the front chassis 2.5" to 3" below factory ride height for an aggressive, level truck stance without sacrificing travel.
-
Dual-Flex Full-Taper Technology: Two tapered leaves deliver a progressive spring rate with built-in safety redundancy over mono-leaf designs.
-
SuperSlide Inter-Leaf Damping: Moly-Nylon friction-reduction buttons eliminate metal-on-metal squeaks, binding, and rust for a softer, quieter ride.
-
Front & Rear Bushings Pre-Installed: Comes complete with pre-pressed front and rear eye bushings to speed up chassis installation.
-
Includes Shorter U-Bolts: Package includes shorter U-bolts specially sized to fit the thinner, high-efficiency 2-leaf pack thickness.
-
American-Made Quality: Hand-assembled and tour-tested in the USA using premium tempered spring steel with proven 100,000+ mile reliability.
Technical Specification Matrix
| Feature / Metric |
Technical Specification Detail |
| Manufacturer & Part # |
Posies Rods & Customs (P/N: D164F) |
| Vehicle Application |
1961, 1962, 1963, and 1964 Ford F-100 2WD Pickups |
| Suspension Location |
Front Beam Axle |
| Stance Drop |
Approx. 2-1/2" to 3.0" Lowered Front Stance |
| Leaf Architecture |
Dual-Flex Tapered 2-Leaf Pack with SuperSlide Buttons |
| Included Hardware |
Sold as Pair; Pre-Installed Front & Rear Eye Bushings; Shorter U-Bolts |
| Optional Hardware |
Rear Front Spring Shackle Kit Available (Part #164FSP) |
| Package Weight & Size |
Approx. 42.0 lbs per Pair (48.00" L x 9.00" W x 6.00" H) |
Technical Installation Notes
-
Bump Stop Clearance: Because this kit lowers the front axle by 2-1/2" to 3", factory frame bump stops must be trimmed down or removed entirely to allow full suspension travel.
-
Axle Alignment: After installing lowering front springs on early Ford F-100 beam axles, verify front axle caster and toe-in alignment to prevent uneven tire wear.
